|Server IP Address||220.127.116.11|
Blip Asset is tightly integrated with this software platform.
The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.
When you activate a device, the following SMS commands are sent from server to device:
|SMS command from
Server to Device
|SMS reply from
Device to Server
||Time period settings
| apn123456 <apn_name> <apnUser> <apnPass>
|| APN ok
|| Set up APN name
||Time zone settings
| adminip123456 18.104.22.168 47735
|| adminip ok!
||Set up server address and port
Some parameters will depend on your cellular network operator:
- <apn_name> – APN name
- <apn_login> – APN login
- <apn_pass> – APN password
As soon as these commands are executed the GPS tracker will connect to the server, and the rest of configuration process will be done via GPRS channel.
- Do not set any password on the device (by default: “123456”)
- Do not set any master number prior to the device activation
- Do not set the Time zone, it must be UTC+0h as per default
- Do not set any pin-code to your SIM card
If you experience problems with automatic device activation, you can send the commands manually, and your device will become activated on the platform.