Carscop CCTR-809

Manufacturer:

Carscop CCTR-809 is an affordable, portable asset tracking device for general-purpose asset tracking.

Carscop CCTR-809 description

Location and tracking

GPS, A-GPS and LBS support, support both continuous and interval modes

Mobile networks

GSM Frequency: 850/900/1800/1900 MHz. No 3G support.

Power supply

Hi-capacity in-build 6000 mAh Lithium battery

Local and remote management

The device can be remotely managed by SMS or GPRS

Portability:

The tracker features waterproof casing (class IP67) and 4 magnet pins, which allows it to be attached to any metal surface.

Specifications and Features

Supported features

Server Integration
Server IP Address217.23.132.215
Server port47735
Housing
Weight90 g (3.17 oz.)
Size77x53x29 mm (3.03x2.09x1.14 in)
Hardware features
Emergency buttonFeature can be supported upon request
Feature can be supported upon request
Tracking features
Tracking modesContinuous, Interval
Feature can be supported upon request
Location by Cell IDFeature already supported
Feature already supported in
Self monitoring
Network signal levelFeature already supported
Feature already supported in
GNSS signal levelFeature already supported
Feature already supported in
Internal battery levelFeature already supported
Feature already supported in
Remote management
Server connection setup over SMSFeature already supported
Feature already supported in
Remote device configurationYes (over GPRS), Yes (over SMS)Feature already supported
Feature already supported in

Server software

Navixy

Server Integration
Server IP Address217.23.132.215
Server port47735

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

APN*123456*{apn}
USERNAME*123456*{apn_user},{apn_pass}
IP*123456*{server_ip},47735
MODE*123456*2
START*123456
TIMEZONE*123456*0

The <APN> parameters depend on your GSM carrier.

Reviews

There are no reviews yet.

Be the first to review “Carscop CCTR-809”

2018, TelematicsTalks powered by Navixy | About