Hua Sheng HS 3000G

Manufacturer:

HS-3000G is a Plug & Play 2G+3G OBD GPS tracker that can be installed in cars and trucks. It reads data from car ECU, including mileage, fuel consumption, fuel level, engine temperature, DTC code, VIN and more. It also record driving behavior data and send to server for analysis. It is widely used in fleet management and insurance telematics.

Hua Sheng HS 3000G description

HS-3000G is a Plug & Play 2G+3G OBD GPS tracker that can be installed in cars and trucks. It reads data from car ECU, including mileage, fuel consumption, fuel level, engine temperature, DTC code, VIN and more. It also record driving behavior data and send to server for analysis. It is widely used in fleet management and insurance telematics.

Location and tracking

  • GPS (JRC or uBlox)
  • Continuous and interval tracking modes
  • LBS is not supported

Mobile networks

  • 2G: GSM/GPRS 850/900/1800/1900MHz
  • 3G: UMTS/HSPA 2100/1900/850/900MHz

Power supply

  • 12 or 24 V

Inputs and outputs

  • OBDII connector

Other features

  • Plug & Play
  • Small size
  • OTA firmware upgrades

Specifications and Features

Supported features

Server Integration
Server IP Address217.23.132.215
Server port47692
General information
PurposeVehicle
InstallationDIY
Housing
Weight60 g (2.12 oz.)
Size62x48x20 mm (2.44x1.89x0.79 in)
GNSS Location
Internal antenna (GNSS)
GPS
Connectivity
Cellular network typeGSM Quad Band, UTMS 850/1900/2100, WCDMA/HSPA
Internal antenna (Connection)
Cellular network generation2G, 3G
Hardware features
Emergency buttonOptionalFeature already supported
Feature already supported in
Hardware extras
Fuel level sensor readingFeature already supported
Feature already supported in
Tracking features
Tracking modesContinuous, Interval
Feature already supported in
OdometerFeature already supported
Feature already supported in
ECO drivingFeature already supported
Feature already supported in
Self monitoring
Network signal levelFeature already supported
Feature already supported in
GNSS signal levelFeature already supported
Feature already supported in
External power source voltageFeature already supported
Feature already supported in
Remote management
Server connection setup over SMSFeature already supported
Feature already supported in
Remote device configurationYes (over GPRS)Feature already supported
Feature already supported in

Server software

Navixy

Server Integration
Server IP Address217.23.132.215
Server port47692

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following command to the device:

g1,set,217.23.132.215:47692:{apn}:{apn_user}:{apn_pass}

The <APN> parameters depend on your GSM carrier.

Reviews

There are no reviews yet.

Be the first to review “Hua Sheng HS 3000G”

2018, TelematicsTalks powered by Navixy | About