Queclink GL520

Manufacturer:

GL520(M) is a GPS locator featuring long standby time. It is powered by user replaceable CR123A lithium battery pack with a built-in battery toggle switch. Configuration allows it to wake up on a preset schedule to check if it needs to shift from dormant to active status and/or send update of its current location, and then return to a dormant state. With built-in light sensor, GL520(M) can monitor removals of the device itself and send alerts.

Queclink GL520 description

GL520(M) is a GPS locator featuring long standby time. It is powered by user replaceable CR123A lithium battery pack with a built-in battery toggle switch. Configuration allows it to wake up on a preset schedule to check if it needs to shift from dormant to active status and/or send update of its current location, and then return to a dormant state. With built-in light sensor, GL520(M) can monitor removals of the device itself and send alerts.

Location and tracking

  • Continuous and interval tracking modes
  • LBS Support

Mobile networks

  • 850/900/1800/1900 MHz
  • 2G Network

Power supply

  • 2 Build-in batteries (1400 mAh)

Other features

  • Remote management
  • Magnet (GL520M)

Specifications and Features

Supported features

Server Integration
Server IP Address217.23.132.215
Server port47764
General information
PurposeAsset
InstallationNot required
Housing
Weight80 g (2.82 oz.)
Size90x39.8x20 mm (3.54x1.57x0.79 in)
GNSS Location
Internal antenna (GNSS)
GPS
Connectivity
Cellular network typeGSM Quad Band
Internal antenna (Connection)
Cellular network generation2G
Tracking features
Tracking modesContinuous, Interval
Location by Cell IDFeature already supported
Feature already supported in
Events monitoring
Battery lowFeature already supported
Feature already supported in
Self monitoring
Network signal levelFeature already supported
Feature already supported in
GNSS signal levelFeature already supported
Feature already supported in
Internal battery levelFeature already supported
Feature already supported in
Remote management
Server connection setup over SMSFeature already supported
Feature already supported in
Forced GNSS location update over SMSFeature can be supported upon request
Feature can be supported upon request

Server software

Navixy

Server Integration
Server IP Address217.23.132.215
Server port47764

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

AT+GTQSS=gl520,{apn},{apn_user},{apn_pass},3,,1,{server_hostname},47764,{server_ip},47764,,10,0,,,0001$

The {APN} parameters depend on your GSM carrier.

Reviews

There are no reviews yet.

Be the first to review “Queclink GL520”

2018, TelematicsTalks powered by Navixy | About